Air compressor oil and gas separator filter how to change

This article is to teach you how air compressor oil and gas separator filter replacement, the beginning or the air pressure surface oil and gas separator are summarized, and then to tell the oil and gas separator filter replacement.

air compressor oil and gas separator filter, oil and gas separator is to put the oil well production of oil and associated gas separation of a device. Oil and gas separator between the submersible centrifugal pump and protector and free gas in the well fluid and completion fluid separation, liquid for submersible centrifugal pump, gas is released into the tubing and casing annulus.

air compressor oil and gas separator filter to replace the

air compressor oil and gas separator filter to replace: when the compressor lubricating oil consumption increase greatly, check the oil filter and piping, return pipe is blocked and after cleaning, oil consumption is very big still, degradation of oil and gas separator has been commonly, need to change in time; When the oil and gas separation filter pressure difference on both ends of 0. Should be replaced when 15 mpa; When the pressure difference of 0, which indicates that filter has a fault or air has a short circuit, this is also applied to replace filter.

generally change the time of 3000 ~ 4000 hours, such as poor environment when its use will shorten the time. Replace the steps as follows:

( 1) Model, the external type

a, compressor stop, air compressor export closed, open the drain valve, confirm there is no pressure force system.

b, oil and gas separator will be removed after the replacement product.

( 2) , built-in models

a, compressor stop, air compressor export closed, open the drain valve, confirm there is no pressure system.

b, break above the barrels of oil and gas pipeline, at the same time, exports to the valve on the pressure maintaining cooler piping to be removed.

c, remove the return line.

d, remove the cover of the retaining bolt on the barrels of oil and gas, remove the gas barrel cover.

e, remove the oil and gas separator with new oil and gas separator.

f, installed in accordance with the open of the order.